BestReviews is reader-supported and may earn an affiliate commission. Details
Menu
 
Expert Shopper Lawn & Garden

Best gas-powered pole saw

Alvina Wang/BestReviews

Which gas-powered pole saw is best?

When you need to trim the tops of the trees, and you have an entire forest to treat, it’s time to get a gas-powered pole saw. But there’s more to it than just the fuel. You also need to balance aspects of the blade and pole to ensure you have the appropriate tool for your job.

The best gas-powered pole saw is the Echo 12-inch Two-Stroke Gas Pole Saw With Loop Handle. The extending pole gives you flexibility when needed, and the handle makes it more comfortable to use.

What to know before you buy a gas-powered pole saw

Gas vs. electric

Gas-powered pole saws have several benefits over corded or battery-operated saws, but they also have several drawbacks.

  • Gas pole saws provide more power than electric ones, can be used anywhere and run longer without needing a top-up. However, they’re also heavier, which makes using them for long periods difficult. Gas engines also require more maintenance, have more expensive fuel (which also generates dangerous emissions) and make enough noise to damage unprotected ears.
  • Electric engines can’t match the power of gas, though high-end ones can get close. Their fuel is cheaper and has no emissions but comes with drawbacks such as limited range for corded saws or short run times for battery-operated ones. However, they’re lighter and tend to cost less.

Two- vs. four-stroke engine

Most gas-powered pole saws use two-stroke engines, but some use four-strokes.

  • Two-stroke engines are more powerful but burn out faster and need more maintenance. You also need to mix your gasoline and oil, which gets messy and can ruin the engine when done improperly.
  • Four-stroke engines aren’t as powerful, but they’re more durable. You also don’t need to mix your fuel, making it easier and cleaner to use.

What to look for in a quality gas-powered pole saw

Pole length

The length of the pole determines how high a tree you can trim. Most poles are 6-12 feet long. Some are telescoping, so you can adjust the length as needed.

Blade length 

Blade length determines how thick a branch you can cut, with the thickness being half the length of the blade. For example, a 10-inch blade can safely cut branches up to 5 inches thick. Most pole saws have 10- or 12-inch blades, but some are shorter.

How much you can expect to spend on a gas-powered pole saw

They can cost as little as $150 or as much as $1,000-plus. Smaller and less powerful saws typically cost $200 or less, while the longest, biggest and strongest start at roughly $400. The average saw costs $250-$300.

Gas-powered pole saw FAQ

How do I maintain a gas-powered pole saw?

A. The biggest step is ensuring your fuel is mixed properly if you have a two-stroke engine. Otherwise, keep the blade sharp and oiled, and make sure no other pieces and parts are clogged or broken.

How do I use a gas-powered pole saw safely?

A. Pole saws and tree trimming are dangerous, so you must take multiple precautions.

  • Saw: Always double-check your pole saw before beginning. Make sure it has enough fuel and that the fuel is mixed correctly if necessary. Make sure the saw is well-oiled and sharp and that the chain is properly tense. Check for any other possible issues.
  • You: Always wear full protective gear when sawing. This means tightfitting clothing that covers all your skin, thick or steel-toed boots in case something falls on your feet, gloves, and either safety glasses or a face shield. It’s also vital to wear proper hearing protection — without it, prolonged use of a roaring gas engine can easily damage your hearing.
  • Area: Make sure there’s nothing and no one around you that branches can fall on. Make sure you have solid footing on stable, preferably flat ground and that you aren’t standing underneath the branches you’re cutting.

What’s the best gas-powered pole saw to buy?

Top gas-powered pole saw 

Echo 12-inch Two-Stroke Gas Pole Saw With Loop Handle

What you need to know: This is top-quality and has useful features.

What you’ll love: The pole telescopes from a minimum of 8.9 feet up to 12.2 feet, and it’s made from aluminum for durability and to keep the weight down. The saw is 1 foot long and has a side-accessed tensioner. The rubber-coated handle is comfortable.

What you should consider: A few consumers had issues assembling it. Others found it a little too heavy. It doesn’t have an automatic chain oiler, making maintenance harder.

Top gas-powered pole saw for the money

K Nakasaki Two-Stroke Five-in-One Pole Saw

What you need to know: This all-in-one collection is an excellent way to fill out your tool shed.

What you’ll love: The five tools are a pole saw, weed eater, brush cutter and two types of hedge trimmers. It also comes with safety gear, including gloves, ear protection, safety goggles, a face shield and a vibration reduction harness.

What you should consider: It isn’t as powerful as a dedicated tool. A few customers didn’t receive instructions. Others reported faulty or missing parts.

Worth checking out

DeWalt 10-inch Two-Stroke Pole Saw

What you need to know: This is an excellent tool for the average household’s occasional trimming needs.

What you’ll love: The pole is 7 feet long. The blade is 10 inches long with a low-kickback chain and an automatic oiler to keep things running smoothly. The saw is also a removable attachment; you can attach other DeWalt tool heads, such as a leaf blower and a hedge trimmer.

What you should consider: A few purchasers had issues with the bar tensioner not working as it should. Others had problems with the automatic oiler clogging.

Want to shop the best products at the best prices? Check out Daily Deals from BestReviews.

Sign up here to receive the BestReviews weekly newsletter for useful advice on new products and noteworthy deals. 

Jordan C. Woika writes for BestReviews. BestReviews has helped millions of consumers simplify their purchasing decisions, saving them time and money.
 

Share this post: